Check Sets
CADD Standards • Version 1.0
Check sets are normally done at half size or ledger size (11x17), at
intervals set by the Project Manager. When possible these half size
plots should be run on a laser printer due to time constraints of
using a full size plotter. Unless the sheet can fit to a scale, most ledger
size plots may not be at a true scale. Full size plots are to be run
at the request of the Project Manager, these plots should be schedules
through the MIS. A group of plots exceeding 10 sheets shall be run
overnight or contracted out-of-office.
SD Graphics • 2319 Benbrook • Carrollton • Tx • 75007 • (972) 446-6366
Copyright © 1998 SD Graphics. All rights reserved. Last updated: Monday, February 2, 1998